Is the car AC carbin filter the same as the air filter? It's different. The function of the air filter element is to filter the particulate impurities in the air, to ensure that sufficient clean air enters the cylinder, and to prevent the dust suspended in the air from being sucked into the engine, causing the wear of the piston group and the cylinder. The function of the car air conditioner filter is to filter the impurities, small particles, pollen, bacteria, industrial waste gas and dust contained in the air entering the cabin through the air conditioner, so as to improve the cleanliness of the air. Automobile air-conditioning filters prevent such substances from damaging the air-conditioning system, provide a good air environment for the occupants in the car, and prevent glass from fogging.
1. The maintenance of car AC carbin filter
Check and replace the car ac cabin filter in accordance with the maintenance plan. In dusty or heavy traffic areas, car AC carbin filters may need to be replaced in advance. If the airflow from the vent is significantly weakened, the filter may be clogged. Check the filter and replace it if necessary. If the air conditioning system is used without a filter, the system may be damaged. To prevent damage to the system, make sure that the filter is installed. Do not use water to clean the car AC carbin filter. When cleaning or replacing the car's air-conditioning filter, the air-conditioning system must be turned off first.
2. The maintenance of the air filter
The dry inertial air filter device is composed of a dust removal hood, a deflector, a dust outlet, a dust cup, etc. During the maintenance, attention should be paid to these: always check and clean the dust discharge hole on the centrifugal dust removal hood, and remove the adhesion on the deflector. Pour out the dust in the dust cup. During the installation, the sealing performance of the rubber gasket at the connection should be ensured, and there should be no air leakage, otherwise the air flow will be short-circuited, reducing the air rotation speed, and greatly reducing the dust removal effect. The dust hood and diversion should keep the correct shape. If there is a bump, it should be shaped in time to prevent the airflow from changing the flow direction of the original design and reducing the filtering effect.